Industrial & petrochemical
ASTM A516 Grade 60 and 70 pressure vessel plate
ASTM A516 is carbon steel plate for pressure vessels in moderate- and lower-temperature service; Grade 70 is the grade most used for vessels and boilers.
ASTM A516/A516M covers weldable carbon steel plate for pressure vessels and boilers in moderate- and lower-temperature service, in grades 55, 60, 65 and 70. The grade number is the minimum tensile strength in ksi.
General requirements, including the supplementary tests, are in ASTM A20/A20M. Ahan Assa sources A516 plate to your list; prices are on request.
Price on request
Normalizing and supplementary tests
- Under the standard, plates over 40 mm thick are normalized; thinner plates are usually supplied as-rolled unless the order asks for normalizing.
- Charpy impact testing at a stated temperature (supplementary requirement S5 of A20) is done only when the order specifies it.
- Ultrasonic examination of the plate (e.g. to A435 or A578) must also be stated in the order.
Grade 60 or 70?
Grade 70 is stronger; Grade 60 has less carbon and higher elongation. The grade is chosen by the vessel designer under the design code.
Tensile properties of ASTM A516 grades
| Grade | Tensile strength (MPa) | Min. yield (MPa) | Elongation in 200 mm (%) | Elongation in 50 mm (%) |
|---|---|---|---|---|
| 55 | 380–515 | 205 | 23 | 27 |
| 60 | 415–550 | 220 | 21 | 25 |
| 65 | 450–585 | 240 | 19 | 23 |
| 70 | 485–620 | 260 | 17 | 21 |
Max. carbon (heat analysis, %)
| Plate thickness (mm) | Grade 60 | Grade 70 |
|---|---|---|
| ≤ 12.5 | 0.21 | 0.27 |
| 12.5–50 | 0.23 | 0.28 |
| 50–100 | 0.25 | 0.30 |
| 100–200 | 0.27 | 0.31 |
| > 200 | 0.27 | 0.31 |
Values are the standard's requirements; the actual values of each plate are in its MTC.
Source: ASTM A516/A516M, Pressure Vessel Plates, Carbon Steel, for Moderate- and Lower-Temperature Service — tensile requirements and chemical requirements (heat analysis).
What to state in an A516 order
- Grade (60 or 70) and plate thickness, width and length
- Whether normalizing is required
- Supplementary tests (Charpy with temperature, ultrasonic)
- Number of plates or total weight
- MTC type and inspection
Documents you can request
- MTC to EN 10204 type 3.1, where the mill or supplier issues it
- Third-party inspection or a 3.2 certificate, on request and as agreed in the proforma
- Packing list and heat number traceability
Frequently asked questions
What is A516 Grade 70 used for?
Pressure vessels, boilers and equipment whose design code allows the grade; the final choice is the designer's.
Is A516 plate always normalized?
No. The standard requires it above 40 mm; for thinner plate, state it in the order if you need it.
Can A516 be replaced by structural plate?
No, unless the vessel designer approves; pressure vessel plate has its own chemical, tensile and testing requirements.
What does A516 plate cost?
It depends on grade, thickness, normalizing, tests and quantity, and is quoted on request.
Send the project's material list
Send the MTO, BOQ or purchase list as Excel, PDF or a photo. Our technical team checks it against the standards and proposes sourcing for each line. Industrial items are quoted on request.